CCNA2 v6.0 Chapter 3 Exam Answers
1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP* EIGRP OSPF RIP 2. Which routing
Read more1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP* EIGRP OSPF RIP 2. Which routing
Read more1. A ping fails when performed from router R1 to directly connected router R2. The network administrator then proceeds to
Read more1. A network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed
Read more1. Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts? It uses
Read more1. What are two advantages of static routing over dynamic routing? (Choose two.) Static routing is more secure because it
Read more1. A network designer must provide a rationale to a customer for a design which will move an enterprise from
Read more1. In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is
Read more1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP*EIGRPOSPFRIP 2. Which routing protocol is limited
Read more1. What are three primary benefits of using VLANs? (Choose three.) security*a reduction in the number of trunk linkscost reduction*end
Read more1. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? If the LED is green, the
Read more